Playing Card Box with Bambu Lab logo

This model is an adaptation of the Parametric Box – Print in Place (Fusion 360), but is not parametric. It includes an inlaid Bambu Lab logo, but can be printed without it if you assign the same filament to both model colors.

There are two sizes available:

• ~25mm = 20mm box inner height + 4mm lid inner height
• ~30mm = 25mm box inner height + 4mm lid inner height

Join the lid to the box using a length of filament:

1. Insert a piece of 1.75mm filament through the hinge when closed
2. Mark the length
3. Pull out the filament a bit and snip off the excess just before the mark to make it flushed or recessed
4. Push the filament back into the hinge with another piece if filament

This box is a perfect container for the Bambu Playing Cards!

Use the 25mm box for the 0.24mm cards, or the 30mm box for the 0.30mm cards.