Description
1x1 Gridfinity bin.
In my country, 6mm magnets are expensive, so I made a model using 5x1mm magnets.
Use when strong magnets are not required.
Other size models will be uploaded gradually.
(I'm sorry that I'm not good at English.)
Refinements
- Use 5mm magnets instead of 6mm magnets.
- No glue needed. Just insert it from the side and push it in until you hear a click.
- Few materials as possible. (example: 1x1x3 bin with label, the amount of material is less than 9.5g.)
- Prints faster. (example: 1x1x3 bin with label, the printing time is less than 27 minutes.)
- It has a little more capacity than the standard one.
Printing
- ! Important ! Be sure to use a layer height of 0.25mm.
- Use 0.4mm nozzle and Line width of 0.42mm.
- Infill of 10%.
Installation
Insert the magnet from the side as shown in the photo.
Push it in until you hear a click and complete. (No glue required.)
To remove the magnet, use tweezers to push it out through the hole at the bottom.