P1P Spool Roller
Copyright Claim
P1P Spool Roller
Boost
29
45
11
Print Profile(2)
Roller V1
Designer
1.6 h
2 plates
Roller V2
Designer
1.7 h
2 plates
Open in Bambu Studio
Boost
29
45
11
0
99
61
Released
Description
NEEDED: 2x 608zz bearings
adhesive (optional)
P1P Spool Holder
NOTE: Supports are somewhat difficult to remove.
NEW: The V2 model has taller lobes on the ends of the roller holder to keep the spool from sliding off of the end.
The bearings should fit snug into the housings, but the ends of the roller rod will need to be glued into place (or not, it seems to work fine without glue too). The roller does have a bit of wiggle without glue, but with a small amount of pressure it seems to grip the bearing just fine. This is a simple roller I made for fun, it seems to work well.
Comment & Rating (11)
All
Print Profile
Roller V1
Printed great but i noticed if you don't put a stopper for the spool the spool will fall off the holder
The designer has replied
1
Reply
Thanks for the comment! I uploaded a new version that will hopefully fix the issue. The lobes are a bit taller; enough to hopefully keep the spool from falling off.
(Edited)0
Reply
Ca tourne bien, même trop bien, ça déroule les bobines
0
Reply
Print Profile
Roller V1
1
Reply
Print Profile
Roller V1
1
Reply
Print Profile
Roller V1
1
Reply
Print Profile
Roller V1
1
Reply
Print Profile
Roller V1
0
Reply
Print Profile
Roller V1
0
Reply
Print Profile
Roller V1
0
Reply
Print Profile
Roller V2
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld