AMS DryPods for Xiaomi Temperature and Humidity Monitor Clock 2
Remixed by
Copyright Claim
AMS DryPods for Xiaomi Temperature and Humidity Monitor Clock 2
Remixed by
Boost
41
120
32
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.6 h
1 plate
Open in Bambu Studio
Boost
41
120
32
5
502
191
Released
Description
AMS DryPods for Xiaomi Temperature and Humidity Monitor Clock 2
Xiaomi Temperature and Humidity Monitor Clock 2 is a cheap solution to watch the condition inside AMS.
AMS的干燥盒，前置接口适配小米温湿度计2，测试PETG成功打印。
Comment & Rating (32)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Xiaomi Temp and Humidity 2 Sensor fits perfectly. Profile was so far so good, except the support. Supports would have been printed in areas where no support was needed.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:I had to reprint two of the boxes because of wrong supports in your print profile. That cost me 4h and 60g of filament. In general the design is good but this profile is not correct if you print directly from the Bambu app and can not see how it is sliced. The supports are both inside and outside and can not be separated. With this support the box does not fit into the AMS.
0
Reply
上传的中间那个干燥盒不是适合方形小米的。是适合圆形的干燥盒。和图中不一样。可以改一下。
The designer has replied
0
Reply
适用的哦，只是打印配置引用的图片是原始作者的方案，实际打印出来是适配小米温湿度计2的
0
Reply
Boosted
nice
0
Reply
downloading the raw files is not correct. the zip name is ok, but inside the zip i find the drypods full set, for the round humidity sensor not the xiaomi variant.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
some support dont needed
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great design and the Mi Monitor 2 just feets perfectly. Thanks,
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld