I made this for my living room with a minimalistic approach on the design.
This is a 2 part print.
The lamp spine can be printed on a small bedsize like the ender 3 if you place it diagonally on the bed. (it will not fit an A1 mini)
To assemble the lamp you need to print the 3 parts.
Parts needed:
E27 socket.
80mm or 120 mm globe bulb.
Wire and plug.
Wire the cord through the base of the lamp, then put the cord lock over the wire, then glue the spine into the base.
The cord lock should be mounted on the top of the lamp to ensure the wire follows the guide on the back of the spine (see pictures).
I found the parts I needed for the project on amazon and aliexpress for less than 10$
Size of lamp assembled:
28 x 14 cm (11" x 5.5")