Magnetic screw holder (drill / screwdriver)

Magnetic screw holder (drill / screwdriver).
Simple and fast print with no supports needed.

• 8 minutes model printing time (on Bambu), without supports. PLA works fine.
• Holds the screw in position when using the drill/screwdriver
• Automatically release at the end
• Adds magnetic feature to the screwdriver/screw drill bit

What you need:

• 7mm diameter and 1-2mm thickness.
• 2gr. of red filament …. kidding :))

Making process:

• This is designed to be used with a small magnet: 7mm diameter and 1-2mm thickness.
• The diameter of the screwdriver / drill bit is 10mm ( tested by me on 10mm, but should work even if it's not tight; this is supposed to move freely )
• print as in the picture, flat, no supports are needed. No special requirements. I used 0.2 layers, but you can go even 0.1mm if you want as the part is so small and fast to print.
• Use a drop of glue or hot gun silicone to fix the small magnet.
  

You can check all my models → here.
Or check my collection of my best models:

https://makerworld.com/en/collections/1921582-my-best-models