Search models, users, collections, and posts
Sagrotan Soap Dispenser Wall Mount
IP Report
Print Profile(2)
0.2mm layer, 5 walls, 25% infill
Designer
2.6 h
2 plates
0.2mm layer, 5 walls, 8% infill
49 min
1 plate
Open in Bambu Studio
Boost
361
1505
194
70
1.6 k
1.3 k
Released
Description
I used Klexer's model, but I always had to remove the soap to take the dispenser out. So I redesigned it from scratch and directly made it look a bit smoother.
I made two versions, one with a flat backside and one with a small 0.4mm recess to use it with thicker adhesive tape.
No support needed. I printed in PLA with 0.2 layer height.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (194)