Search models, users, collections, and posts
Gridfinity Bin Lids
IP Report
Print Profile(2)
Standard PETG, ironing on
Designer
59 min
2 plates
Standard PETG, ironing off
Designer
42 min
2 plates
Open in Bambu Studio
Boost
478
2047
54
21
1.2 k
416
Released
Description
Update 16/12/2023 - 1x1 Lid Prototype added to print profiles by request. STLs added.
-------
I designed these lids to help carry fasteners and small objects around. I think they make great little gift boxes to make Gridfinity converts!
Status: Beta
Compatibility
- Designed for 1.2mm wall divider bins
- However, mainline bins were considered and should be compatible (it would be good if someone could test it and report back!)
Print Settings
- PETG recommended for durability and ease-of-use (this is designed for PETG)
- If you have PLA with good layer adhesion, that may work for you
- Transparent PETG can show you what's inside somwhat - use a smooth plate and turn ironing on. Print slow with flowrate capped to 8mm3/s or lower, and increase the flow ratio from the default 0.95 to perhaps 0.99 to reduce the air bubbles inside.
Sizes
- More to be added as I need them but please feel free to remix your own sizes!
Check out this collection for my other Honeycomb Storage Wall models and
check out this collection for my Gridfinity models.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (54)