Standard Door Hook
Copyright Claim
Standard Door Hook
Boost
13
10
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
13
10
10
0
47
57
Released
Description
Simple Standard sized door hanger hook printed in PETG for a bit of flex
.20 layer
no brim
19 minute print on X1c for a single.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in ludicruous speed (160%), quality ok for a hook.
And two pieces in sport mode, these were in much better quality.
thank you
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I like the hook it works well! I would prefer the hook to have a rounded end for manufacturing I believe the square end provides a more reliable print
(Edited)The designer has replied
1
Reply
Hi thanks for the comment, made a rounded version now as well and published
https://makerworld.com/en/models/80720#profileId-85885
(Edited)1
Reply
Replying to @Nethuntr
Thank you so much!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works perfect! printed in pla
The designer has replied
1
Reply
Great, Thanks for the feedback
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great hook. Fit over door well with no issues. Print was clean and solid using petg
The designer has replied
1
Reply
Great, Thanks for the feedback
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
strong
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld