Pumpkin Spider Robot (no MMU needed)
Remixed by
Copyright Claim
Pumpkin Spider Robot (no MMU needed)
Remixed by
Boost
33
54
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
5 h
4 plates
Open in Bambu Studio
Boost
33
54
7
0
86
73
Released
Description
All parts are already in the correct orientation to be printed.
Support:
- Mandatory for the shell (only the part where the leg attaches)
- Highly recommended for the legs. Legs can be printed vertically without support, but they will be weaker and take longer to print.
- Recommended for the large eyes
Assemble is mostly straightforward as parts snap in place and can rotate freely to the correct position. You will need to glue
- The Torso to the Torso Bottom Spacer to the Torso Bottom. Try to keep all parts centered, but if you can't there is no big deal
- The eyes to the head
- The Head to the Head Top. There are little dowels that are intentionally loose. They are there just to guide the top part position in relation with the head.
Comment & Rating (7)
All
My daughter loves this spider.
0
Reply
my 6 years old daught like the toy, unfortunately we created green version. it is too tight for Assembly, kids can't do the assembly.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it kept on failing, and did not work. I had to go to blender and fix it myself.
The designer has replied
0
Reply
I think you may got some problem in your slicing software, I use this print config works well, and no need to use blender to fix it. and some other people works well also.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld