Good print. Sits perfectly on a shelf without falling over! Had a few issues with the arm and head not adhering but I also resized it for the A1 Mini plate so that's probably what happened. It was an easy fix with a little gel super glue though.
My son says it looks just like the game but the print is flawed, I printed the 1st one in PETG bc that was the only yellow I had... there was a large spot of stringing at the back of the neck which resulted in decapitation when I tried to clean it up, and the right arm fell off at the shoulder. The exact same thing happened in both areas to the 2nd print which I did in PLA to see if that made a difference... it did not. I might question my printer's settings but I just printed a much more complicated articulated sloth with zero issues... 4/10 (for accuracy of looks) would not recommend.
The one arm isn't connected to the shoulder at all. Both prints had the head look like it fell apart at the supports. Since the back isn't flat and all the parts are raised from the bed there are a ton of difficult to remove supports. I printed in PLA on a textured plate and on a flat plate. Same issues both times so I think this print needs to have a few improvements. Good idea missing some things.