Search models, users, collections, and posts
Stork
IP Report
This model is created by Image to Keychain
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
36
69
9
4
109
55
Released
Description
Stork - Baby Magnet. This image to key-chain model has three negative cylinder parts for 4×2mm round magnets. Here is a link to the ones I used: Magnets
This model is 3.5mm thick and uses 4 colors therefore I recommend to print with the AMS unit.
Colors I used:
Yellow → Bambu PLA Matte Lemon Yellow
Gray→ Bambu PLA Matte Ash Grey
Back → Bambu PLA Matte Charcoal
White → Bambu PLA Matte Ivory White
Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (9)