Bubble Popper (TPU)
Copyright Claim
Bubble Popper (TPU)
Boost
42
83
79
Print Profile(2)
New and Improved! 0.2mm layer, 3 walls, 5% infill
Designer
44 min
1 plate
A1 mini, 0.2mm layer, 2 walls, 5% infill
43 min
1 plate
Open in Bambu Studio
Boost
42
83
79
5
328
432
Released
Description
Push the Bubble in and then it comes back! Printed in Ninjaflex TPU
Comment & Rating (79)
All
The print profile is no longer public
I gotta work on printing tpu...
(Edited)
The designer has replied
0
Reply
Bummer. Maybe slow down or lower extruder temp?
0
Reply
Replying to @3Dylan
thanks i will try that... just started printing with tpu
0
Reply
Replying to @robherdzik
Just wanted to let you know I've added a v2 profile with much improved TPU parameters!
(Edited)1
Reply
Print Profile
New and Improved! 0.2mm layer, 3 walls, 5% infill
There was a slight adhesion issue on the first layer, but the print completed.
The designer has replied
0
Reply
Looks good! Cool color!
0
Reply
Print Profile
New and Improved! 0.2mm layer, 3 walls, 5% infill
Prints well standing up but the TPU I used doesn't 'pop'
0
Reply
Print Profile
A1 mini, 0.2mm layer, 2 walls, 5% infill
not sure if it's fault of my filament but it came with a lot of stringing
Other Issues
0
Reply
Print Profile
A1 mini, 0.2mm layer, 2 walls, 5% infill
speed seems a little high, I had to tweak a few things for my TPU, I couldn’t get the bubble to pop unfortunately, and it struggled to print part of it, but cool design :)
0
Reply
came out almost perfect
0
Reply
Print Profile
New and Improved! 0.2mm layer, 3 walls, 5% infill
it always comes back but never pops to the other side
0
Reply
can you make one that's a 2x2 or 4x4
The designer has replied
0
Reply
sure! though I think it might get wobbly if you go taller. I'll have to try it out
0
Reply
possibly but thx
0
Reply
Print Profile
New and Improved! 0.2mm layer, 3 walls, 5% infill
profile prints way to fast for TPU in the vertical orientation.
The designer has replied
0
Reply
what issue did you have? happy to improve the profile
0
Reply
Interesting. I used the default bambu tpu settings for some 85a ninjaflex and it printed ok. Maybe dropping the flow rate to 2 would be more consistent
0
Reply
Boosted
Print Profile
New and Improved! 0.2mm layer, 3 walls, 5% infill
Great print! This blew my daughters mind that I 3D printed a “pop it” toy!
The designer has replied
0
Reply
glad you and your daughter liked it!
(Edited)1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld