Phone Holder, smooth tilt adjustment, prints in place Remixed by Veiko1

Remixed by

Veiko1

Household>Office

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill, no-brim

Designer

3.9 h

1 plate

4.6(98)

Boost

171

319

126

1 k

937

Released

Description

From original post:

Phone holder with an angle adjustment knob allowing for fine control of tilt. Prints in place, no supports.

Phone holder allows for fine control of tilt. Probably overkill for some uses, but think this might be useful for video chat or work conferences where you want to get the camera angle just right.

Link to adjustment demo GIF: https://drive.google.com/file/d/1McKVSAtGteZpH0tnaasFR7kEc2QWJiKA/view?usp=sharing

A little PTFE lube helps it run smoother

Comment & Rating (126)

@JustGrimm

was this suppose to print inside? or am I missing a step? 😅

The designer has replied

@Veiko1

yes, you need to print as it is in the file

@Mymaxdom

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

Absolut Cool das Teil. Vielen Dank dafür

The designer has replied

@Veiko1

Thanks

@atisakson

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

came out perfectly. I printed mine with a brim but I’m not sure if it was necessary. either way the end result is great!

@scaleoss

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

Nice

@user_3864056220

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

Great design, smooth gears, loving this. thank you! I used Amolen Rainbow rock PLA

@WebstersCreatio

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

prints perfect

@ominousgneiss0x

Printed perfectly and works like it should!

@hoffmann.ingo

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

Tolle Druckdatei, Funktioniert ohne Probleme, das Spiel könnte ein klein bischen geringer sein aber ansonsten wirklich Top

@3D_Gnom

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

Ideal für den Schreibtisch

@Calipitter

Print Profile

0.2mm layer, 2 walls, 15% infill, no-brim

eigentlich sehr schön... leider rutscht das Oberteil immer nach unten und hält die Position nicht... ich habe das mit Isolierband gefixt... wäre toll wenn das Model nochmal kommen würde in etwas stabiler