Christmas ornament Bells by Mr.Jay

Mr.Jay

Household>Festivities

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.24mm layer, 5 walls, 15% infill

Designer

26 min

1 plate

4.8(15)

Open in Bambu Studio

Boost

174

103

Released

Description

UPDATED: bottom of the bells was not attached. Fixed in the new files.

A Christmas ornament with bells.

Size is 85mm x 92mm

I printed it upside down to get a nice finish

Comment & Rating (24)

@KidBuu

Print Profile

0.24mm layer, 5 walls, 15% infill

Great Job!

The designer has replied

@Mr.Jay

@Kid Buu thanks You can support me by downloading more of my files ;-)

(Edited)

@KidBuu

Replying to @Mr.Jay :

definitely! just got me ams so I’m excited to do multicolor coasters!

@LloydTapper

Print Profile

0.24mm layer, 5 walls, 15% infill

Very elegant ornament. Looks great when printed upside down.

The designer has replied

@Mr.Jay

Thanks!

@mario1979

Print Profile

0.24mm layer, 5 walls, 15% infill

my first print wirh my a1. fantastic! 😃

The designer has replied

@Mr.Jay

Nice print. Be careful with your A1. Bambu is recalling the heatbed and advise not to print with it until it is replaced!

@Amn2009

Print Profile

0.24mm layer, 5 walls, 15% infill

A few questions: Print was nice while I never really normally print in 0.24 mm Draft quality. But: 1. I printed it with the provided profile, and maybe it is due to the textured PEI plate, but the side you look at to read the text, was twarted, while the side facing up had the bells contour, and actually looked nicer. I either need to print using the cold plate, or flip it back 180 degrees and print it like that…? 2. In the slicer the dot over the i is shown, but does not attach to anything, so is just left on the plate….? 3. On printables the exact same model and text is present, but from a user Jochem, I assume that is you under a different name?

The designer has replied

@Mr.Jay

Thanks for your comment. Personally I found the textured plate gave a nicer finish. That's why the models are flipped. But you are free to flip it back to show the bells contour. I choose the draft quality for faster print. The layer lines are not important so it's useless to print with lower layer height. I know the dot over i is not attached. I noticed it later, but I don't mind it. If I attach it, the text is harder to read. Yes my profile name on printables is Jochem ;-)

(Edited)

@threadstone

Print Profile

0.24mm layer, 5 walls, 15% infill

@owenquinroberts

The print profile is no longer public

the bottom of the bell fell off, is not attached

The designer has replied

@Mr.Jay

Thanks for your comment. I checked the print profile. I found the profile didn't include arachne wall generation, so it didn't print well. I updated the file and increased the width of the connection of the bottom of the bell and it should print fine now.

(Edited)

@ideopraxist

I love this. One issue though was that the left hand side bell bottom dropped off after printing. It was probably my fault as I printed it with standard pla silk settings?

The designer has replied

@Mr.Jay

Thanks. I had no problem with mine and I also printed it with Silk PLA. Did you use my profile? Also it is important to take it of the bed carefully.

(Edited)