Christmas decor Merry Christmas
Christmas decor Merry Christmas
Boost
48
98
31
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
48
98
31
0
167
115
Released
Description
Merry Christmas decoration
Comment & Rating (31)
All
most likely damp bambu sample filament :( otherwise EXCELLENT design :)
The designer has replied
0
Reply
what bed plate are you using, looks like bed is very dirty. need to clean it regularly .
thx for printing
0
Reply
Replying to @SlowpoksWorksho
stock bambu cold with bambu glue stick , cleaned 2 prints ago... maybe i need to tram the bed, will try again today
0
Reply
Replying to @9H1LOStan
if you don't have a textured pei plate , I suggest you get one, no glue and prints rarely fail
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Great design. Came out super cute. It is a little fragile, with only a small amount of material connecting the "merry" to the snowflakes that are connected to the "Christmas", so be prepared to handle it carefully, but the dainty/lightweight design is part of what makes it look so nice! I used the ironing function and you almost can't tell it's 3D printed. Merry Christmas!
The designer has replied
0
Reply
very nive..Thx for printing ;-D .
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Had to substitute gold sparkle. I think it came out great.
The designer has replied
0
Reply
very nive..Thx for printing ;-D .
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
printed in smaller format, 8cm , and white ASA
0
Reply
in the picture it seems to be a four color print but the profile is three.
it seems to be missing green I was curious before I committed to a print if the lettering on the Christmas would be gray instead of green and if I changed it to green would the gray on the snowflakes be green as well?
The designer has replied
0
Reply
Hello,it definitely has 4 colors ,white,blue gray, red and green.
1
Reply
Replying to @SlowpoksWorksho
okay thank you on your prepared to print page it shows two gray colors so that makes a little difficult for people to figure out which one to change to the proper colors it's a 50/50 chance that they'll get it right seeing that the profile picture is face down on the build plate. and I'm not sure if you meant to mention but I think you stated five colors up there in your comment. thanks in advance
(Edited)0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
sorry took so long to rate. thank you for the solid print
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
straight to the front door! looks good!
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
it’s too flimsy. I’m going to make it thicker and try it again.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
came out looking really good!
0
Reply
is there a way to get the normal .stl file please?
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld