This is very cute, and I want this to work very badly. The default setting puts in enough support that it is no longer considered support. I just started using a Dremel on the top (inside). Please note that blood will stain PLA. LOL.
I am going to print this again with less support. Any tips or suggestions would be appreciated!
Hi! The support are supposed to be in PETG to avoid sticking with PLA, that's why there is no gap between supports and model, did you change it from the print profile ?
It should be easy to remove like that.
If you haven't PETG, you can use regular support in PLA of course (but revert default support settings) !
What layer do I need to pause in order to switch over to the 5th color if I'm using my X1 Carbon with only one AMS and can only do 4 colors at a time??? I NEED three different colors of sprinkles despite my husband trying to convince me that the far simpler answer would be to narrow it down to three colors total... :/
I love this print so much. I did the pink version which turned out pretty good. You can see some of the blue through it. But the best one so far is the chocolate sprinkle! Looks so good. Make sure you use petg as the interface and the supports pull out fairly easily. Pls author make a maple bar version (called long johns where I'm from). It would make a perfect storage box with so much room inside. I need a whole collection of different donuts :D
Hi, PLA and PETG shouldn't stick together, so it should be easy to remove, try to jiggle a little bit. Once it starts to be removed at one place it will easily pop off!