Fidget Cube
Copyright Claim
Fidget Cube
Boost
32
70
15
Print Profile(2)
0.2mm layer, 2 walls, 15% infill, run on silent
Designer
41 min
1 plate
0.2mm layer, 2 walls, 15% infill, 50% Speeds + Silent Mode, Inner Brim
54 min
1 plate
Open in Bambu Studio
Boost
32
70
15
0
164
91
Released
Description
This is a fidget cube I designed. Run it with the print profile and on silent it should run smoothly
Comment & Rating (15)
All
Had 4 or 5 fails until I got the settings to print this start to finish without failing.
First thing I had to swap PEI plate to Cool plate
cut any speed in the settings 50% slower and then use silent mode to make sure there weren't any fast pulling or pushing from the print head.
Last thing I had to turn inner brims on, that way the ball won't move while printing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, run on silent
Löst sich leider vom Druckbett
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, run on silent
will need some sanding, but feels very solid!
(Edited)
0
Reply
hey could I sell your design
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, run on silent
messed up
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, run on silent
did not finish print. needs some kind of support.
0
Reply
failed 2 of the poles broke
0
Reply
it failed....need to try it again
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, run on silent
Hat bei mir leider nicht geklappt mit der Kugel wegen dem extremen Überhang
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, run on silent
Probleme beim.drucken...äussere Schicht abgebrochen
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld