Search models, users, collections, and posts
Sword
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10.6 h
3 plates
Open in Bambu Studio
Boost
3
3
0
0
2
0
Released
Description
This sword was made so the inside is hollow this will allow a light to be put inside to make it glow. The sword prints in separate sections and assembly is needed. The pins to hold the blade in the handle are made so the blade can be removed.
Blad prints in 4 pieces - with the middle section of the blade allowing being able to connect to each other to make a longer sword
Hande prints in 2
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)