Voronoi Wrist Rest for Keyboard / 键盘肘托
Boost
17
34
2
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
12.6 h
1 plate
Connector and Rods, slightly smaller for snug fit
57 min
1 plate
Open in Bambu Studio
Boost
17
34
2
0
65
14
Released
Description
Finally I could have my own wrist reset for my keychron.
The dimension is 360 x 68 x 22 mm. and it is foldable to fit into your bag.
No support needed.
The diameter of the axis insert has already been adjusted, and due to the elephant effect, it might be tight to insert into the hole.
I suggest to apply some lubricant into the holes and use the hammer, after the insert is completely installed, the rotation is smooth.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed well overall. Needed to do an additional print of the rods and connector because they were so tight and fragile that they broke when I tried to assemble them. I ended up printing the rods upright with a brim, increased their infill to 100%, and thinned it out from 4mm to 3.9mm.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld