11-10-2023 Added V2 of snowman spinner. No support, easier printing.

Quick, simple print of a spinning/fidget toy.

Pieces seem to fit together better/tighter if you use a Textured Build Plate.

Pieces should just snap together if your filament is dialed in. If not you may require a little glue.

Let me know if there are any issues so I can fix them. Any criticism to help me improve is appreciated.

Print at a 0.16 layer height.

• X1 and X1C users: Disable flow calibration before printing the multicolor variants of these prints. Otherwise it will print on top of the flow calibration lines.

ASSEMBLY

1. Put the 3 pegs into the part with the snowman faces in it. There are 3 small hexagon holes for them to press into.

2. Put snowman face part into the round base.

3. Slide the ring onto the lip of the base and press down all the way around slowly until snug.