2x 1kg Spool Holder for Ikea Skadis 165mm by 9arr3tt

9arr3tt

Tools>Organizers

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

0.28mm layer, 2 walls, 15% infill

Designer

46 min

1 plate

4.9(25)

0.28mm layer, 2 walls, 15% infill

58 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

150

251

226

Released

Description

Holds two 1kg filament spools

V2 (1/2/2024)

Revised model! Added better structural support, thicker, no sag, better hook design

For best results print in PETG. It should also work in PLA with my print profile but I have not tested to confirm yet.

Comment & Rating (32)

@Holyvision

The print profile is no longer public

Print it in PETG strength settings and it takes two spools no issue. I would do a V2 with additional structural support, but works great for holding empties.

The designer has replied

@9arr3tt

Thanks for the feedback! My set ended up breaking after 2 months so I went ahead and designed a V2 that is available now, give em' a try if you'd like!

@tim.bleeke3

Print Profile

0.28mm layer, 2 walls, 15% infill

Fits well

@Martog

Print Profile

0.28mm layer, 2 walls, 15% infill

Prints fine with PLA, I'm only using mine for empty spools though.

@GoldenSilence

Print Profile

0.28mm layer, 2 walls, 15% infill

Worked great for my use case

@CADKrieger

Print Profile

0.28mm layer, 2 walls, 15% infill

einfaches aber sehr praktisches Modell. Danke

@adrian_ApeX

Print Profile

0.28mm layer, 2 walls, 15% infill

no issues, printed fast

@onurb_ch

Print Profile

0.28mm layer, 2 walls, 15% infill

@philip.laureano

I noticed that it only holds two 1kg spools before the hook starts to droop. I had to run two of these hooks through the middle of two spools on my Skadis boards to support the weight of two spools. It's still a good hook, but in reality, it only supports 1kg per spool

The designer has replied

@9arr3tt

Thanks for the feedback! My set ended up breaking after 2 months so I went ahead and designed a V2 that is available now, give em' a try if you'd like!

@philip.laureano

The stress point in the original version seems to be at the top part of the hook. It might be worth reinforcing the top part by having it clamp into three Skadis holes, like an eagle claw. Reinforcing the rest of the hook is mostly unnecessary because it is the failing stress point that is causing the rest of the hook to start drooping. You can see that the rest of the hook remains intact.