Box with Sliding Lid - Free 3D Print Model

Search models, users, collections, and posts

Contributing Factor

Tools>Organizers

IP Report

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

Updated model: 0.2mm layer, 4 walls, 10% infill

Designer

4.7 h

2 plates

4.9(14)

Old Version: 0.2mm layer, 2 walls, 15% infill

Designer

4.5 h

2 plates

4.7(3)

Open in Bambu Studio

Boost

177

276

130

Released

Description

Feb 9 2025: Updated the model to improve the design of the rails and give it a much stronger, secure click-lock.

Convenient, compact box with sliding lid.
14cm x 14cm x 8cm in size.
Lid slides and clicks into place.

Remains securely closed when stored upright.
Place thumbs on top, press gently and slide back to open.
Shown item was printed using Overture Sandstone Rock PLA.

Smaller version of this box available here.

Printing Instructions

Prints without supports and fits on a two A1 mini plates.
Please make sure the parts are fully cooled before lifting them from the plate or they will deform.
After printing, the lid might fit a bit tight depending on printer and filament performance. Slide the lid on and off the box a few times to create a good fit between the two parts. This might take some force and it's normal for small strings of plastic to separate from the lid and the box. Alternatively you can sandpaper the rails on the lid slightly to improve the fit.

Please remember to rate your prints!

Profile ratings are not only important for other users but also serve as valuable feedback for designers!

Click here to see my other models

Boost Me (for free)

If you like this model, please boost! It's free to you, but it's a meaningful way to support me and my designs.

General 3d Printing Tips

Make sure your printing plate is clean! Oils from your skin can cause adhesion issues for your prints. Regularly wash your print plate with a detergent like Dawn, and avoid touching the surface when removing prints from the bed.
If it's an option on your printer, always level the bed before each print. If you have to perform this manually, do so after every few prints. It takes a bit of time and patience, but it's a fair trade for reliable results.
Ensure bed and nozzle temperatures are within the expected range for the material you're printing. Temperatures that are too high or too low can negatively affect the print, causing warping, malformed layers, or adhesion issues.
Reduce your printing speed. Slower speeds are especially important for overhangs, as they give the material more time to cool as it's deposited.

Membership

Click here to obtain a commercial license to sell physical prints of my 3D models.

Join