Wall Mounted Tape Hook
Copyright Claim
Wall Mounted Tape Hook
Boost
33
82
12
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
52 min
1 plate
Open in Bambu Studio
Boost
33
82
12
2
119
131
Released
Description
A hook designed for hanging rolls of tape on the wall in my garage. Two mounting holes are present but for small loads only the top hole is required. May be useful in other applications as well.
Mounted with 1x #8 self drilling drywall anchors (Cobra WallDriller or similar). Recommend using a drywall anchor or direct mounting to a stud with a #8 screw. Adhesive/double sided tape/3M command strips may work for light loads as well.
Comment & Rating (12)
All
Boosted
Print Profile
0.2mm layer, 6 walls, 25% infill
printed great with the profile, supports came off super easy. The design is sturdy, however it was difficult to find a good screwdriver to get the top screw in, eventually got it done, will print more. thanks
The designer has replied
1
Reply
Glad you were able to make it work, it looks good! I may be able to open up the counterbore diameter on the screw holes to allow for larger diameter screwdriver shanks or to let you get at it from more of an angle. Thanks for the feedback.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
PERFECT thanks !!
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
just what I needed!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld