Search models, users, collections, and posts
Horns
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
10.3 h
2 plates
Open in Bambu Studio
Boost
74
213
11
8
124
46
Released
Description
I had a hard time figuring out how to orient the horns to print. Several fails and a lot of support tweaks later, I tried this setup, and it worked pretty well. I still needed to sand a bit to smooth out the edge, but I was happy with results. In response to que4stinos from others I wanted to post my settings in case they help others. Good luck!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (11)