Clock Stand for Desk v2.0 for 170 + 245 mm dials

https://makerworld.com/en/collections/4639439-licensed-models

You can sell this model, and all the models in the link above, 
with a membership on Patreon.
www.patreon.com/cP_3D

Hello, I'm sure you've already seen or printed one of my dials? Here is my overview….. over 400 Clockfaces: https://makerworld.com/en/collections/1715414-wall-clock-hueforge 

I have properly redesigned the stands for the table for the 170mm models. Now the back can be locked in the stand and the clockwork can be covered. Overall, it now feels more valuable. I hope you like my table clock.

Would you like to put the clock on the fridge? Then visit this link:
https://makerworld.com/en/models/643115-magnetic-back-for-my-245-and-170-mm-dials

You can find an LED module for the dials here:
https://makerworld.com/en/models/643259-led-module-for-my-170-and-245-mm-dials

Here you can find my other dials collected
https://makerworld.com/en/collections/1715414-wall-clock-hueforge  

You can find clock hands for other quartz clock movements here:
https://makerworld.com/en/models/540231#profileId-457599

First place the clock movements

put the rubber over the shaft

attach the dial with the nut

Assemble the clock hands

Set the time before closing the lid

To mount the stand on the back plate, you have to pay attention to the grooves....after attaching it, turn it so that it clicks into place

and the clock is ready 😁 Have fun with it