Dremel Bit Holder, No Infill
Copyright Claim
Dremel Bit Holder, No Infill
Boost
17
23
2
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
5.5 h
1 plate
Open in Bambu Studio
Boost
17
23
2
0
46
21
Released
Description
Summary
Eliminates needs for infill by printing as two separate pieces. Holds 51 (including 3 w/ larger heads) 1/8in shank bits.
Can be filled with sand to weigh it down before sealing the top.
Comment & Rating (2)
All
Had problems with the profile on my X1C with PLA, 0.4 nozzle, textured print bed.
Cleaned print plate with Isopropanol on forehand.
See foto - the part with the holes did not stick to the printed and by that made a mess in the printer. Due to black filament the auto spaghetti recognition did not kicked in. I will try again later with a brim for these part.
In generell it is a good modell.
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld