Search models, users, collections, and posts
Pet Table
Print Profile(1)
0.28mm layer, 3 walls, 15% infill
Designer
13.5 h
4 plates
Open in Bambu Studio
Boost
8
32
1
2
16
10
Released
Description
This is a set of interlocking pet tables I created for our cat, she's 13 and doesn't like bending down to her dish, so these raise them up a bit for her. There's two types one with a solid top and one with a hex grid on top, I would recommend the solid one as it's easier to clean.
They are all 80mm high, the top of the square tables is 140mm x 140mm the corner table is 45 degree so 140mm on the side and about 88mm alon the back.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)