Drafting Card box display for Dune Clank andMore by Righteous

Righteous

Toys & Games>Board Games

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

Imrpoved Card Draw - 0.2mm layer, 2 walls, 15% infill

Designer

1.5 h

1 plate

5.0(2)

0.2mm layer, 2 walls, 15% infill

Designer

1.6 h

1 plate

Open in Bambu Studio

Boost

112

Released

Description

updated and enhanced

I noticed in smaller decks (uprising) the cards were not easy to get out as I wanted
This enhanced version makes it easier to get cards out, with a finger area down and to the bottom.
Making it easy to drawn down to the bottom of the deck
same great top where you can display cards

These five card holders stack well, and can be used to split up your imperium row. Then you just open them up and it has a place on each of them to display your imperium cards. . .

Would work well on Clank too

Printed perfectly on a P1S - fits sleeved Dune Imperium cards (more space for unsleeved)

Comment & Rating (4)

@user_3511592856

Boosted

Very happy with the design and print. Added 3.15 mm to the lid length for a flush fit with the box. Also added 0.7mm to the lid width for a snug fit to prevent unintentional opening.

@ericmg123

Awesome design, thanks! Just printed to test with PLA Tough. For Dragon Shield sleeves, this box holds about 32 cards. If I were to print more boxes, I'll probably increase the Y scale by a few mm; right now it's pretty tight on that axis - the cards scrape as you pull them out. Not a huge deal but it is a bit more snug on that axis than I'd prefer. Again, thanks a lot for posting this. My group loves Dune and Clank and this is a really nice storage / setup solution.

(Edited)