Minimalist Hydrometer Holder by JBeahn

JBeahn

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

18 min

1 plate

4.8(44)

0.2mm layer, 2 walls, 15% infill

15 min

1 plate

4.0(2)

Boost

178

183

Released

Description

This is a minimalist Hydrometer holder for us in the Bambu Lab AMS. This is for a panel-mount style Hydrometer with a panel cutout diameter of 42mm (such as sold here: https://www.amazon.com/dp/B0C3767NVS?psc=1&ref=ppx_yo2ov_dt_b_product_details). The stand uses less than 5g of filament but holds the hydrometer nicely so it saves on cost but also leaves the back of the hydrometer wide open for measuring humidity in the air of the AMS. Personally printed out of PLA and it perfectly fits the bill.

Comment & Rating (48)

@Jman472

Print Profile

0.2mm layer, 2 walls, 15% infill

Fast little print! keep my meter from rolling on my desk!

@projectresolute

Print Profile

0.2mm layer, 2 walls, 15% infill

good model, although the back could extend a bit further.

(Edited)

@PCHuDSoN

Print Profile

0.2mm layer, 2 walls, 15% infill

just what I needed.

@Harry.S

Print Profile

0.2mm layer, 2 walls, 15% infill

not too bad of a print, used to compare moisture outside my AMS to inside it

@Molback

Print Profile

0.2mm layer, 2 walls, 15% infill

Simple holder if you don't need to move them around. Try something more robust if you not placed in a steady location. it meets the description well, does not use a lot of filament to print.