Table Leg Extender

Dimensions:

Bottom - 58mm wide x 15mm high

Top - 58mm wide x 3mm wall x 10mm high

My problem wich ended with this project:
I bought an old tabel and some old chairs, but the chairs couldet go under the table.

I designed a circel in TinkerCad with a diameter on 58mm wide and 15mm in height.
On top og that i made a circle with a hole in the same diameter of 58mm and set the wall for 1 which made it 3mm wide, so it wont brake off, so the hole is 55mm wide. I made the wall 10mm high, so the extender works like a cork and you dont need any screws.

You can modify the model for fitting your table leg. Measure the diameter and fit the model to it.

Hope someone can use this.