Christmas ornament
Christmas ornament
Boost
2
5
3
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
23 min
1 plate
0.2mm layer, 3 walls, 15% infill
23 min
1 plate
Open in Bambu Studio
Boost
2
5
3
0
8
3
Released
Comment & Rating (3)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
For the most part this printed fine. Has a strange second loop at the top that doesn't print right with the provided profile. Change the wall generator to Arachne and it prints. Just not sure why it is there. There is also a small piece on the bottom right that is seperate from the rest of the colored layer. This caused a little bit of spaghetti with the provided profile.
0
Reply
Here is the difference with the Arachne wall generator. I added the profile with the Arachne wall generator. Please feel free to take it down if you don't want it up there. I asked for the points to go to you. :)
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld