Print Profile(2)
v2 fixed
Designer
5.1 h
2 plates
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
2 plates
Open in Bambu Studio
Boost
47
74
30
1
95
76
Released
Description
unfortunately i don't have the right colours to print this yet but will update pic once its printed.
Comment & Rating (30)
All
Got it printed and it looks great. What is the square hole for in the side? I can’t find a rocker switch that would fit in there?
(Edited)
The designer has replied
1
Reply
Just to feed the cable through
1
Reply
ahhh ok. I might open it up with a file to fit a switch in it. thanks for the reply!
0
Reply
hi do you mind if i add your picture to the model?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I had an issue with the two pieces fitting together under the tail, but it could have possibly been my printer (x1c). I just had to clip 2 spots with my nippers and it fits great! my Girlfriend loves it.
2
Reply
thanks so much love the design! however there is lots of gaps and holes when sliced and it seems very thin could maybe use another layer :)
The designer has replied
0
Reply
Its supposed to be thin to let as much light as possible through, as for the gaps is detect thin walls on?
0
Reply
Replying to @cruse2382
yes it was, might try with a 0.2mm nozzle and see if it makes a difference :)
1
Reply
Print Profile
v2 fixed
looks good. easy to print.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
awesome!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice model; the bottom is a bit hard to insert. A filling is missing between the head and the leg, which I plugged before slicing the model.
Thanks for sharing!
1
Reply
Print Profile
v2 fixed
Other Issues:The back of the box did not fit the front, it was way to small. The front came out beautifully! I’m excited to try to figure out resizing the back to fit so I can assemble it.
The designer has replied
0
Reply
do you have any pictures of your issue as i have printed this a couple times and the back has always fit perfectly.
0
Reply
Replying to @cruse2382
I will upload a picture in a few minutes
0
Reply
here are the pictures
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Missing Model Parts:tiene demasiados abujeros
The designer has replied
0
Reply
what parts are you missing as ive just checked and its all there.
0
Reply
Replying to @cruse2382
Donde esta el cuadrado rojo, es un hueco vacio por completo.
Donde estan los circulos verdes, se quedan abujeros al ser impriso con boquilla de 0,4mm en la x1 carbon
0
Reply
Replying to @davidalcocer1di
i have fixed the hole in the red square and i have re uploaded with a new profile that should fix the holes but not had tie to print it yet as printer is busy for the next few days buts looks better in the slicer. sorry about that
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print
1
Reply
i printed the box and but the backs printed too small tried upsizing but caint seem to get a back to fit
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld