PiggyBank LowPoly
Remixed by
Copyright Claim
PiggyBank LowPoly
Remixed by
Boost
34
78
19
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
1 plate
125% 0.2mm layer, 2 walls, 15% infill
10.4 h
1 plate
Open in Bambu Studio
Boost
34
78
19
1
260
162
Released
Comment & Rating (19)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
queda genial
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed fine. just can't get the circle "plug" to fit in the bottom of the bank to close it.
(Edited)0
Reply
Supports?
0
Reply
If the plug is difficult to install, grinding the edges of the plug can solve the problem
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:model failed almost at the beginning without support. print profile is awful
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
125% 0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld