Toothpaste stand

This is a simple model that can hold your toothpaste upright. My toothpaste has a small cap and always falls over, so I figured I would make this. Also, as you can see my toothpaste isn't even taller than my toothbrushes, it's rather small. If you have a large toothpaste bottle go with the wide profile. All toothpastes should fit in the smaller one, but they may topple over if they're too tall.

Print settings:

• spiralized/vase mode
• 0.16mm layer height

The rest is up to personal preference. My profiles use “0.16mm High Quality” instead of "0.16mm Optimal", that way the outer finish looks a bit better.