Simple Generic LED remote holder for the LED Desk Lamps sold on Aliexpress, Including STEP of the remote I have.
This is a simple and quick to knock out design and print done in an evening after work so it might not be as refined as it could be. STEP included so any remixes are more than welcome. Please put any makes up or any notes on refinements I might incorporate into more in depth projects I’m working on.
Note due to weight of item and placement for my use I never fully fleshed out screw hold design, this may mean in your use case not all screws will allow for a nice fit.
Double Sided tape (command strips) are what I have used to good effect.

4.36g Filament – PLA+ - 3x3x3 It will print solid so infill doesn’t matter

Updates
V1_1 - Removed need for supports for holes and overhangs
V1_2 – Updated top of model to be cut off at a lower height and cleanly to remove potential tall stability issues on untuned machines.

Anycubic

Doesn't Matter

0.2

Note due to weight of item and placement for my use I never fully fleshed out screw hold design, this may mean in your use case not all screws will allow for a nice fit.
Double Sided tape (command strips) are what I have used to good effect.

This was a rapidly thought of and sketched model. Basically a quick measure and extrude for the remote and an even quicker Rough extrude out of some little arms to hold it in. Concept image in the images and Step files provided if you want to see the shocking process of over though that got this made in a short time.