Remix of Hex Bit Box into a keychain, using a twist-lock design on the lid that <clicks> in place when secured and a hole for a keyring.
Very easy print with minimal supports that easily pull off.
The keychain box stores up to 12 bits securely. Bits can be easily snapped in for storage and snapped out for use.

For extra convenience, the holder will stand upright on the cap when it's removed from the storage box.
The lid uses a twist-lock design that secures it by twisting in either direction.

Click here to see the original design
Click here to see my other models

General 3d Printing Tips

• Make sure your printing plate is clean! Oils from your skin will cause adhesion issues for your prints. Regularly wash your print plate with a detergent like Dawn and avoid touching the surface when removing prints from the bed.
• If it's an option on your printer, always opt to level the bed before each print. If you have to perform this manually, make sure you do this after every few prints. It takes a bit of time and patience, but it's a fair trade for reliable prints.
• Ensure bed and nozzle temperatures are within the expected range for the material you are printing. Temperatures that are too high or too low will affect the print negatively by causing warping, malformed layers or adhesion issues.
• Reduce your printing speed. Slower print speed is especially important for overhangs because it gives the material more time to cool as it's deposited.