Thank you so much for your review!
I'm glad you liked the print.
However, I'm not quite sure I understand your comment about needing to make 2 of them to hang things.
Could you kindly provide more details or clarify what you mean?
I would be happy to assist you in the best way possible.
Hi, ofcourse. The print was too thin to hang basket on it from the skådis ikea collection. So i printed two of them to make it kinda double layerd. I'm absoluty happy with the outcome, so thank you!
El diseño es bueno y ahorra material respecto a otros diseños parecidos, pero la distancia entre los agujeros no es la misma que en el skadis original, así que las piezas originales no te serviran, es una lastima.
Oh, that's very strange.
I designed the model based on the dimensions I found online.
Is what you used for comparison an original IKEA SKADIS?
Maybe I'll try getting one to replicate the correct measurements.
Came out really well and precise, it fits perfectly combined with some Skadis standoffs off Makerlab. Also uses a fairly minimal amount off filament despite being sturdy and looking awesome.
For me it's 1:1 with a SKADIS ... IDK why some are having problems ... maybe in some circumstances and some mounts yes. Or is this after an updated model from you?
Thickness is 5 mm for both.
Thank you. Will rate when MW lets me
Tolles "Modell", eine zweite (größere) Variante die das Druckbett des X1C ausreizt wäre klasse. dann wäre das Skadis Board vielleicht noch eine Lochreihe höher und breiter. So in Richtung 220x220mm oder 250x250mm (wird wahrscheinlich schon zu eng mit der Flusskalibirierung)
