AMS spool adapter for Sunlu 250g spools - v2 Remixed by kyriosyesous

Remixed by

kyriosyesous

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 6 walls, 25% infill

Designer

6.6 h

2 plates

5.0(63)

Open in Bambu Studio

Boost

109

346

663

Released

Description

12/13/2023 - Revised with finer resolution (No longer low poly)

This is a slightly over engineered version of my first adapter for the Sunlu 250g spools to fit the AMS. Added a locator pin to prevent the spool from spinning. Added spacer to prevent filament tangling between the spool and adapter.

Comment & Rating (87)

@SillySnax

Print Profile

0.2mm layer, 6 walls, 25% infill

Works as intended. But the model has a low polly tecture compared to V1 and arn't perfectly round so they dont roll as smooth.

(Edited)

The designer has replied

@kyriosyesous

Thanks, I will update this shortly

@kyriosyesous

Updated to finer resolution. Should no longer be low poly.

@SillySnax

Replying to @kyriosyesous :

Thanks! Edited to 5 stars.

@gabegoldsby

Boosted

Thank you so so much for this. My first printer was an ender 3 s1 and I purchased two boxes of the 250g from sunlu. Once I got my x1c I just never went back to it because I enjoy using the AMS. Picture is not so great but I printed these with a .6 nozzle and some old filament made absolutely no changes whatsoever to the profile. they look great and they just work. no problem closing the lid either.

The designer has replied

@kyriosyesous

looks great! Thanks for the kind words.

@N0VA333

Print Profile

0.2mm layer, 6 walls, 25% infill

wow these are clean! they fit perfectly! really like the little nub in the center to really lock the spool in!

The designer has replied

@kyriosyesous

Thanks for the kind words and nice review

@wkburkert

Exactly what's needed if you're using SUNLU 250g reels with the Bambu AMS and 220mm diameter reels. Printed mine using SUNLU PLA Grey using .4mm nozzle. Time to try some SUNLU PETG!

The designer has replied

@kyriosyesous

Thank you for the kind review and photos. I'm glad so many people are able to use this as it was just a creation out of necessity when I bought the Sunlu sample pack.

@TheJetsons

Print Profile

0.2mm layer, 6 walls, 25% infill

Wotks as described. simple and effective;) I made two as I needed filament swapping eith AMS.

@KingLoui3

Print Profile

0.2mm layer, 6 walls, 25% infill

it was exactly what I needed! fit perfectly. thank you for sharing.

@johnsonluong8

Print Profile

0.2mm layer, 6 walls, 25% infill

Great Print. Still using till now

@superglidedyna

Awesome, fits and works very well!!!

@krles.ul

Super, thank you :-)

@Aucruzto

The fit is just on point. Great design. Just a suggestion, It would be great if add a sort of holes or something to hang the tip of the filament wherever is located. Thanks!