PTFE tube release tool for the filament buffer and extruder


Print Profile(3)

0.28mm layer, 3 walls, 15% infill
0.28mm layer, 3 walls, 15% infill
Designer
X1 Carbon, P1S, P1P, X1, X1E, A156 min
4.9
Regular, tested print, 0.2mm layer, 3 walls, 25% infill
Regular, tested print, 0.2mm layer, 3 walls, 25% infill
P1S, P1P, X1, X1 Carbon, X1E, A145 min
4.8
PLA 0.20mm
PLA 0.20mm
X1 Carbon, P1S, P1P, X1, X1E, A11.3 h
5.0

188
412
169
1 k
759
Released
Copyright Claim
Model
Comment & Rating
Remixes
Related Models

Description

This is a tool to help release the PTFE tube from the filament buffer on the back, and from the extruder (printhead).

 

Inevitably, one will run into filament feeding problems. This usually requires releasing the PTFE tube from the back of the filament buffer, and sometimes the PTFE tube from the extruder, among other steps. This tool can help to release the tube from both places.

 

Releasing the PTFE tube requires one to push down on a ring that's securing the PTFE tube. In the filament buffer in the back of the printer, the ring is recessed inside and not easy to get to. This tool can push down on the ring without having to open up the buffer.

 

This tool also allows one to press down on the ring on the extruder to release the PTFE tube without opening the extruder (printhead) cover.

 

An ergonomic handle design and finger grip pattern make it easy to use. The handle is long to make it easier to reach and get to the filament buffer in the back of the printer.

 

Easy to print, no support, no brim.


License

Comment & Rating (169)

Please fill in your opinion
0/5000

Print Profile
Regular, tested print, 0.2mm layer, 3 walls, 25% infill
Great print and I'm sure I'll thank myself for printing this before I need to
1
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
This saves me from using a screw driver to get those hard to reach places when things go wrong.
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
Printed perfectly, no issues.
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
printed well and quite handy
(Edited)
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
A bit difficult to use, but that is mostly bambulab's fault. It prints well and function as intended.
(Edited)
0
Reply
Has printed well. Looks beautiful. Thank you!
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
Came out well. No support needed. Used BL PLA Basic. Thank you!
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
Really useful
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
this printed very nice on the x1. works great.
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
Ottimo per levare il ptfe e un casino senza
0
Reply

Remixes (0)

There are no remixes yet