IKEA Skadis Bottle holder
Remixed by
Copyright Claim
IKEA Skadis Bottle holder
Remixed by
Boost
14
48
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
45 min
1 plate
Open in Bambu Studio
Boost
14
48
9
1
55
30
Released
Description
This is a remix of https://www.prusaprinters.org/prints/62937-ikea-skadis-bottle-holder/. I needed a holder for a bottle with 40mm diameter. The opening is slightly bigger with 42mm.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Nicht sehr passgenau!
Nacharbeit an den Haken erforderlich damit diese in das Skadis Board passen.
Ansonsten super Modell für meine Wurkkos TS11 Lampe.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good work but does not fit easily into the Skadis
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
© 2024 MakerWorld