Paper towel holder
Copyright Claim
Paper towel holder
Boost
9
17
6
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
4.6 h
1 plate
Open in Bambu Studio
Boost
9
17
6
2
69
58
Released
Description
Simple screw mounted paper towel holder
Comment & Rating (6)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
does not fit Kirkland paper towel rolls. The cylinder is much too wide. also uses a lot of filament
0
Reply
Resize it?
0
Reply
Replying to @mbraaten83
I tried that. Unfortunately that is not easy to do, as it requires changes to the model. If I resize it down in the slicer, the outer piece that secures it to the wall also shrinks, leaving less room for the roll. So no dice on resizing in the slicer.
(Edited)1
Reply
Printed in PETG for the final version, turned out perfectly! I tried PLA first with the scarf joint enabled in Orca, but it printed the main shaft very poorly. For the final version, I used 4 walls, 15% cross hatch infill, traditional seam, and slowed the outer perimeters to 50 mm/s.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
great model. printed perfectly
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
A very handy item for the garage. Printed very good.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld