Icom ID 52 Desktop Stand
Copyright Claim
Icom ID 52 Desktop Stand
Boost
6
9
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
42 min
1 plate
Boost
6
9
6
1
23
25
Released
Description
Just a simple Stand for your Icom ID52 i believe it would also work with the ID51 but cant comfirm
the hole in the back is for the mic clip
radio can be used with stand still attached
Comment & Rating (6)
All
Hi, great model :-) I printed one for a friend of mine and he was very pleased with it.
Is there any chance I could ask you to make a version with "feet" that stick out a bit more (for added stability)? I was thinking that perhaps you could increase the radius to about 35mm. Then the feet would stick out more and the curve/sweep of each leg would meet the top of the back plate. Thanks in advance.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great and works as described. Using anything but the stock antenna makes it very tippy though
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Handy little stand ! Thanks for sharing print came out great on X1C with PLA from Hatchbox
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld