My old water holder for chickens got broken, so I designed and printed new one. Model was printed with 7% infill, optional supports (I also tried with supports off, but results with supports are better), 0,4 nozzle, 0,2 layer height.

Model is designed wider as original one, so chickens can't turn it around so easily. Bottom side is wide and open, easy to clean it.

I used PETG, cause is more suitable for feeding purposes.

After printing it, you must just find some plastic water bottle, fill it and use it on printed model. There should be enough water that chicken can drink, but cannot make everything around wet.