Airplane Nintendo Switch Hook
Boost
10
25
7
Print Profile(2)
Original Model, 0.4 Nozzle
Designer
34 min
1 plate
Original Model, 0.6 Nozzle
Designer
29 min
1 plate
Open in Bambu Studio
Boost
10
25
7
0
19
32
Released
Description
Switch hook to use on an air plane. Ideally print in PETG for it's elasticity.
Comment & Rating (7)
All
Sorry for the delay! I attached some photos. It fits the same on the OLED switch and a switch original. we tested both.
0
Reply
took a picture of it being used.
0
Reply
I assume this is meant to hook on the tray table when upright and clip onto the switch?
(Edited)The designer has replied
0
Reply
hi! appreciate you found this model. it's a test model for another user, who hasn't come back to me if it fits.
yes, you'd print two of those and hook them onto the tray and slide your switch into it. the measurements should be ok, but I don't own switch to test. if you would like to assist and test it that would be amazing.
it's based on https://makerworld.com/en/models/34035#profileId-31134
0
Reply
Replying to @capsel22
the original print was to tall where the switch went in. I shortened it by about 5mm and now it fits both the regular switch and the oled perfect. Probably only need one now seeing as it snaps on so well.
0
Reply
Replying to @zetzel
oh thats, awesome. Are you able to take a picture? I will add it to the design
0
Reply
No more
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld