Bambu Lab A1 print bed stabiliser (2 pieces)
Print Profile(2)
Description
This is a stabiliser for the print bed of the Bambu Lab A1 printer.
My A1 tends to tilt backwards a little, especially when there is a full filament roll on top of the holder. It is also a little wobbly when moving the print bed back and forth quickly. I can also see this in the print by some warping on the walls of printed objects.
The two clamps are attached to the print bed on the rear side at a distance of at least 4 to 5 centimetres behind the U-support. It is best to push them as far back as possible until they are in direct contact with the feet on the underside. The clamps stabilise the rear area so that it can no longer tip over. Optionally, a third clamp can also be attached from the rear.
I am assuming here that the printer is standing on a flat surface and that no extensions are mounted under the feet (compensators for vibrations).
The printing time for the two stabilisers should be around 1 hour. An hour that was well worth it for me.
As I don't own an A1 Mini, I can't say whether this would also work on the A1 Mini.
Maybe someone will make a redesign for this printer.
Have fun with the stabiliser and please let me know if it works for you.
By the way, the pictures are quick renderings made with Blender - I can't take pictures of my A1 because it's completely built in.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (29)