Summary

This is a simple collector for dust when drilling holes in walls.

It should be attached with temporary masking tape below the area to be drilled. Make sure that the tape covers the top edge to ensure all dust falls into the collector.

Unlike some of those 'Drilling Guides' found on Thingiverse, it allows both hands to be used to hold the drill.

Ensure that you read the 'Misc Notes' below with relation to the alignment when printing.

Print Settings

Printer Brand:

FlashForge

Printer:

Dreamer

Rafts:

No

Supports:

No

Filament:

Matteforge Matte PLA

Notes:

NB: Print with the model aligned upright with the small base flat to the bed. This ensures that the maximum overhang is no more than 45 degrees. Your slicer may try and align it on its back, which will cause an unacceptable horizontal overhang for the front lip.