Esp32cam with PIR. Snap fit housing
Copyright Claim
Esp32cam with PIR. Snap fit housing
Boost
1
2
6
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
46 min
1 plate
Boost
1
2
6
0
11
6
Released
Description
Esp32 cam mount with PIR sensor. Design incorporated for antenna.
I used the guide from dronebotworkshop: https://dronebotworkshop.com/esp32-cam-microsd/
PIR can be ommitied and this unit can be used for Print monitoring - consider port forwarding for access out side your home network to access the camera also.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Support Issue:i could not take down the two pieces. so it was good to throw away the print. idea is genial. yet the print would had been better placed in two parts. not all in one.
The designer has replied
1
Reply
Split the part into objects?
(Edited)1
Reply
Replying to @rd3dprints
yes. yet since was thinking about that after the first print. was too late :)
0
Reply
no problem
0
Reply
Im curious on your hardware setup inside of this.
The designer has replied
0
Reply
AliExpress ESP32CAM module with breakout board. AM312 PIR Sensor. Also AliExpress Antenna.
There are loads of Repositories on Github with ESP32cam sketches of various flavours for your particular needs.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld