LLG Controller Grip
Copyright Claim
LLG Controller Grip
Boost
14
19
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.2 h
1 plate
Boost
14
19
7
1
169
34
Released
Description
Controller grip similar to the Nintendo Switch Joy-Con Grip.
Tolerances might be an issue on the latch depending on your printer and slicer settings.
Can be printed with or without supports depending on the orientation. If you are printing flat, use supports, if printing upright, supports aren't needed.
Filament: PLA/PLA+
Infill: 30%+
Also avialable on Thingiverse
https://www.thingiverse.com/thing:6315454
Comment & Rating (7)
All
Thanks sharing
(Edited)The designer has replied
1
Reply
I did 30% and seemed pretty sturdy.
0
Reply
Thank you kind sir!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
es funktioniert so semigut: die Controller gehen schwer rein und raus und bedingt durch die Form der Controller hat das Druckteil sehr kleine "Nasen" an denen aber viel Kraft angreift. Aus meiner Sicht könnte man es technisch aber nicht besser lösen, weil die Controller nun mal so sind, wie sie sind. Ich nutze das Teil trotzdem nur selten, weil ich meine Controller schonen will und nehm stattdessen nen Xbox Controller. Danke für die Vorlage👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I was very skeptical but this thing actually works!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld