Search models, users, collections, and posts
LLG Controller Grip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.2 h
1 plate
Open in Bambu Studio
Boost
31
56
21
6
326
135
Released
Description
Controller grip similar to the Nintendo Switch Joy-Con Grip.
Tolerances might be an issue on the latch depending on your printer and slicer settings.
Can be printed with or without supports depending on the orientation. If you are printing flat, use supports, if printing upright, supports aren't needed.
Filament: PLA/PLA+
Infill: 30%+
Also avialable on Thingiverse
https://www.thingiverse.com/thing:6315454
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (21)